Configure network interfaces Configure mobile (cellular) interfaces
Digi TransPort WR Routers User Guide 214
Configure and test W-WAN models from the web interface
To configure the TransPort router for the correct APN and PIN code, if any.
1 Make sure the router’s mobile settings is correctly configured as needed, through the mobile
settings described earlier in this section.
2 Power up the router and test the connection to the wireless network.
3 If you have correctly configured everything, the W-WAN SIM indicator on the front panel should
illuminate green to show that a W-WAN enabled SIM card is present.
4 The router will now attempt to log on to the specified mobile network. If it is able to do so, the
W-WAN NET indicator will illuminate steady.
5 Data passing to and from the network is reflected by the status of the DAT indicator, which
flashes green.
6 If you cannot connect to the network, go to the Management > Network Status > Interfaces >
Mobile web page.
7 Click Refresh. A page similar to the following should be displayed. For more on the Signal
Strength status and value displayed, see Signal strength indicators on the Mobile status page.
To Next Page
Loading...
