Digi TransPort WR31 - Using Wildcards; Using Special Usernames in Commands

Use the command-line interface Application commands
Digi TransPort WR Routers User Guide 133
Using wildcards
When viewing and not setting parameters, you can use wildcards in the field <param_name>. For
example, to view all PPP 1 parameters that start with r, enter:
ppp 1 r* ?
The output is:
ppp 1 r* ?
r_mru: 1500
r_acfc: OFF
r_pfc: OFF
r_pap: ON
r_chap: ON
r_accm: 0xffffffff
r_comp: OFF
r_addr: OFF
r_callb: 0
rxtimeout: 23
rdoosdly: 0
restdel: 2000
rebootfails: 0
rip: 0
ripip:
ripauth: 1
ripis: OFF
r_md5: 1
r_ms1: 1
r_ms2: 1
rbcast: OFF
OK
Using special usernames in commands
You can use several special usernames for local and remote authentication:
If a % symbol is part of the username, you must enter another % symbol as an escape character. For
example, enter user%1 as user%%1.
Username Description
%s Uses the serial number of the router as the username.
%i Uses the IMEI of the cellular module as the username.
%c Uses the ICCID of the SIM as the username.