Configure network interfaces Configure Advanced interfaces settings: External modems and PPP
Digi TransPort WR Routers User Guide 299
PPP parameters
This section contains those parameters which may need to be adjusted when setting up a PPP
connection, but in general can be left at their default values.
Load answering defaults
Clicking this button causes the router to read the default PPP answering default parameters
from a default configuration stored in memory.
Load dialing defaults
Clicking this button causes the router to read the PPP dialing parameters from a default
configuration stored in memory.
Description
A description of the PPP instance that may make it easier to refer to. For example, the PPP
instance to connect to an ISP could be named MyISP.
This PPP interface will use
If the PPP mappings have been set up previously using the PPP mappings page, this box will
contain the name of the protocol that has been assigned to this PPP instance. If the mapping has
not been set up previously and if no default mappings apply, the value for this setting should be
Not Assigned. Select the required the required physical interface from the drop-down selection
box.
Dial out using numbers
To allow the router to automatically make outgoing calls, the ISDN number must be specified.
The four text boxes allow four telephone numbers to be entered. The first one is required, the
others are optional, and the router uses the others in rotation. These numbers can be the
number of the Internet Service Provider (ISP) or another router.
To Next Page
Loading...
