Digi TransPort WR31 - Page 298

Configure network interfaces Configure Advanced interfaces settings: External modems and PPP
Digi TransPort WR Routers User Guide 298
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
mlppp 0 l_accm 0x00000000-
0xFFFFFFFF
Desired local ACCM
mlppp 0 r_accm 0x00000000-
0xFFFFFFFF
Desired remote ACCM
mlppp 0 username Valid username username
mlppp 0 password Valid password password
mlppp 0 epassword Encrypted password None-this parameter is not configurable
mlppp 0 r_chap on, off Enable remote CHAP authentication
mlppp 0 l_shortseq on, off
Default off
Enable short sequence numbers
mlppp 0 up_rate 0-2147483648
Default 2000
When the data rate is greater than n bytes/sec
mlppp 0 up_delay 0-2147483648
Default 10
for s seconds
mlppp 0 down_rate 0-2147483648
Default 1000
When data rate is less than n bytes/sec
mlppp 0 down_delay 0-2147483648
Default 10
for s seconds
mlppp 0 dup_rate 0-2147483648
Default 500
When data rate is greater than n bytes/sec
mlppp 0 dup_delay 0-2147483648
Default 5
for s seconds
mlppp 0 ddown_rate 0-2147483648
Default 500
When data rate is less than n bytes/sec
mlppp 0 ddown_delay 0-2147483648
Default 5
for s seconds