Configure alarms Event Logcodes parameters
Digi TransPort WR Routers User Guide 634
Configure event logcodes
To configure events, click on a particular link in the Event Logcodes page’s Event Description
column; for example, Power-up[%c]. The settings for the event are displayed.
The Event Logcodes configuration page controls the configuration of the event that is displayed
in bold font at the top of the page, just below the title bar.
Do not log this event
When enabled, this setting disables logging of the event. This parameter is not saved in the
logcodes.txt file but in the config.dan file. This means that after changing this parameter, you
must save the changes by clicking the save changes link when prompted (this appears after
clicking the Apply button). If you click the Save All Event Code Changes, your changes are not
reflected.
Log Priority
The priority of the event to determine whether the event will trigger emails, SMS messages or
SNMP traps. 0=disabled, 1=highest priority, 9=lowest priority.
Alarm Priority
If the above Inherit alarm priority from event setting is not enabled, this parameter selects the
priority of the reason. Valid values are 0 to 9.
Alarm Priority is dependent on the event being logged by Entity
Selecting this setting makes the priority conditional on which system entity triggered the event,
such as Ethernet, and enables the following two configuration options:
To Next Page
Loading...
