Digi TransPort WR31 - Application Commands Are Case-Insensitive; One Command Per Line; Application Command Syntax

Use the command-line interface Application commands
Digi TransPort WR Routers User Guide 132
Application commands are case-insensitive
Digi application commands (referred to just as text commands or CLI commands throughout the
remainder of this guide), can be entered in upper or lower case.
One command per line
Unlike AT commands, only one command may be entered on a line. After each successful
command, the OK result code will be issued. An invalid command will cause the ERROR result code
to be issued.
Application command syntax
The general syntax for an application commands is:
<entity> <instance> <param_name> <value>
where:
<entity> is the name of the entity.
<instance> is the instance number for the entity that you are configuring.
<param_name> is the name of the parameter that you wish to configure.
<value> is the new value for the specified parameter.
For example, to set the window size to 5 for X.25 PAD instance 1, enter:
pad 1 window 5
Even if there is only once instance of particular entity, enter 0 for the instance number.