Digi TransPort WR31 - Related CLI Commands

Configure legacy protocols Configure TPAD parameters
Digi TransPort WR Routers User Guide 547
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
tpad n l2iface lapb, lapd, tcp, ssl, vxn Use TPAD over interface.
tpad n l2nb 0-255 Use TPAD over interface.
tpad n ipmode 0=XOT, 1=raw TCP Use TPAD over interface.
tpad n bakl2iface lapb, lapd, tcp, ssl, vxn Use backup interface.
tpad n bakl2nb 0-255 Use backup interface.
tpad n bnumber text (valid ISDN number) Use number x to make outgoing
ISDN calls.
tpad n prefix text (numeric) Use prefix x
tpad n prefix_rem text (numeric) Remove prefix x from number in
ATD command.
tpad n suffix text (numeric) Use suffix x.
tpad n tl2deact 0-10000 On the main interface Deactivate
LAPB session x seconds after TPAD
X.25 call has been cleared.
tpad n baktl2deact 0-10000 On the backup interface
Deactivate LAPB session x seconds
after TPAD X.25 call has been
cleared.
tpad n defpak 16,32,64,128,256,512,1024 Default X.25 Packet Size.
tpad n nua text Use NUA.
tpad n nui text Use NUI.
tpad n lcn 1-4095 LCN.
tpad n lcnup 1=up, 0=down LCN direction.
tpad n baknua text (Backup) Use NUA.
tpad n baknui numeric text (Backup) Use NUI.
tpad n baklcn 1-4095 (Backup) LCN.
tpad n baklcnup 1=up, 0=down (Backup) LCN direction
tpad n cingnua numeric text Report our NUA as n to the X.25
network.
tpad n cud text Call User Data.
tpad n samecall 0 One per transaction.
tpad n samecall 1 Allow consecutive transactions.