Configure alarms Event Settings parameters
Digi TransPort WR Routers User Guide 625
SNMP Traps parameters
The router firmware supports the use of SNMP, with the ability to generate traps. To make the SNMP
(Simple Network Management Protocols) functional, a SNMP trap server must be configured. SNMP
trap server configuration is in the Configuration > Remote Management > SNMP > SNMP Traps
menu.
Send SNMP Traps
When enabled, displays the following parameters:
Send a SNMP Trap when the event priority is at least n
The lowest-priority event that will generate an SNMP trap message. For example, if this value is
set to 6, only events with a priority of 6 or lower (7, 8 or 9) will trigger an automated SNMP trap
message. To disable SNMP traps, set this value to 0.
Send a maximum of n SNMP taps per day
Sets the limit on the number of emails that may be sent during any 24-hour period. The intention
is to prevent excessive alerts being sent when the event trigger value is set to a high priority/low
value (for example, 1, 2, or 3), such as a value that results in a large number of SNMP trap
messages being generated. A maximum of 65535 SNMP traps can be sent in a day.
n SNMP traps have been sent today
A status message, indicating how many SNMP trap messages have been sent during the last 24-
hour period.
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
event n trap_trig 0-9
0 disables sending alerts
Send a SNMP trap when the event priority
is at least n
event n trap_max 0-65535 Send a maximum of n SNMP traps per day
To Next Page
Loading...
