Use the command-line interface Application commands
Digi TransPort WR Routers User Guide 131
Application commands
The TransPort device also supports numerous text-based application commands that are specific to
Digi International products, and do not require the AT prefix. Some of these are generic, such as they
are related to the general operation of the router; others are application- or protocol-specific.
This section contains the following information about application commands:
▪ Application commands are case-insensitive
▪ One command per line
▪ Application command syntax
▪ Using wildcards
▪ Using the CLI parameter tables in this guide
▪ reboot command: reboot router
▪ config command: show/save configuration
▪ templog command: temperature monitoring
▪ traceroute command: Troubleshoot connectivity problems
▪ ana command: Clear the Analyser Trace
▪ clear command: Clear the event log
▪ Activate and deactivate interfaces
▪ gpio command: General Purpose Input Output (GPIO)
▪ qdl command: Select cellular image to load
▪ tcpperm command: establish a permanent serial to IP connection
▪ tcpdial command: Establish a manually initiated serial to IP connection
▪ tcpdab command: Cancel a tcpdial connection
To Next Page
Loading...
