Configure legacy protocols Configure TPAD parameters
Digi TransPort WR Routers User Guide 542
TPAD Settings
Use Terminal ID (TID)
Inserts or replaces a Terminal ID in the APACS 30 string.
Replace TID provided by connected terminal with configured TID
When enabled, any Terminal ID provided by a connected terminal is replaced by the ID set in the
Use Terminal ID field above.
The TID will be become inactive in n seconds.
The time, in seconds, before the Terminal ID is considered inactive. Local authorizations may be
configured to occur on active TIDs (terminal Ids), so this parameter defines how long a time
(without transactions) must pass for a TID to change from active to inactive.
Use TID xxxxxxxxx with incoming APACS 50 polling calls
The terminal ID to associate with this TPAD instance when answering an incoming APACS 50
polling call.
To Next Page
Loading...
