Digi TransPort WR31 - Related CLI Commands

Configure UDP echo Related CLI commands
Digi TransPort WR Routers User Guide 502
Do not send any data with the UDP packet
When checked, this check box causes the router to send only a single null data byte. This is
useful to minimize packet size when the interface has high data charges, such as W-WAN. When
unchecked, the router sends packets containing the router’s serial number and ID as text.
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
udpecho n dstip Valid hostname Send a UDP packet to IP address
a.b.c.d port n every s seconds
udpecho n dstport 0-65535 Send a UDP packet to IP address
a.b.c.d port n every s seconds
udpecho n interval 0-2147483647 Send a UDP packet to IP address
a.b.c.d port n every s seconds
udpecho n locport 0-65535 Use local port n
udpecho n userouting off, on Route via Routing table
udpecho n ifent PPP,ETH Interface x,y
udpecho n ifadd Valid interface instance
0-4294967296
Interface x,y
udpecho n onlyis off, on Only send packet when the interface is
In Service
udpecho n nodata off, on Do not send any data with the UDP
packet