Digi TransPort WR31 - Log in to the Device

Use the web interface Log in to the device
Digi TransPort WR Routers User Guide 97
Log in to the device
By default, Digi Transport routers have a static IP address of 192.168.1.1 with DHCP server enabled.
To access the router using a web browser:
1 If the Digi TransPort router is not already connected to a LAN, connect an Ethernet cable
between the LAN port on the Digi Transport and your PC.
Note All TransPort WR models are auto-sensing for 10/100 operation. Most models are also auto
MDI/MDX, such as will automatically work with either a straight-through or cross-over
cable.
2 Make sure your PC is configured to automatically receive an IP address by selecting Start >
Control Panel > Network > Configuration and verifying the configuration.
3 Open a web browser. Enter the router’s Ethernet IP address (192.168.1.1) into your web browser
after configuring your PC to have an address on the same subnet. A login page appears.
4 Enter the default username, username, and the default password, password and click Log In
button. The password appears as a series of dots for security purposes.
Note Digi recommends changing the username and password for all users away from their
defaults. See Change the default username and password for a user.