Configure network interfaces Configure Wi-Fi interfaces
Digi TransPort WR Routers User Guide 175
Wi-Fi Hotspot
This section enables the configuration of the global parameters that are applicable if using any Wi-Fi
node as a hotspot.
Enable Wi-Fi Hotspot on
Enables or disables Wi-Fi Hotspot support on a particular Wi-Fi node.
Splashscreen filename
Selects an ASP web file that will be presented to the client’s internet browser when they connect
for the first time.
Each client can connect for h hrs m mins
The amount of time that a Wi-Fi client can use the Wi-Fi hotspot before having to re-
authenticate.
Require Wi-Fi client authentication
If enabled, specifies that Wi-Fi hotspot authentication is required for Wi-Fi clients. You can then
select the RADIUS configuration to use.
Hotspot Exceptions
It is possible to configure a number of web locations for which authentication is not required.
These settings allow the splashscreen to access these locations in order to display them to the
client when authenticating.
Wi-Fi Hotspot CLI commands
Entity Instance Parameter Values Equivalent web parameter
wifinode n hotspot on, off Enable Wi-Fi Hotspot on
wifi 0 hotspot_fname Filename Splashscreen filename
wifi 0 hotspot_lifetime Integer Each client can connect for h hrs m mins.The CLI
value is entered in seconds only.
wifi 0 hotspot_auth on, off Require Wi-Fi client authentication
wifi 0 hotspot_radiuscfg 0, 1 Use RADIUS instance
hshosts n host Hostname Hotspot Exceptions
To Next Page
Loading...
