Digi TransPort WR31 - Related CLI Commands

Configure IP routing and forwarding BGP parameters
Digi TransPort WR Routers User Guide 390
Advertise non-connected networks
When enabled, BGP advertises networks that exist in the BGP configuration file but that are not
actually a connected network or interface.
BGP Tracing
As with OSPF, the level of debug tracing information is selected from this drop-down list. The
available levels are; Off, Low, Med, and High.
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
bgp 0 enable on,off Enable BGP
bgp 0 conffile BGP Configuration Filename
bgp 0 new_cfg_rest on,off Restart BGP after configuration file is saved
bgp 0 fatal_rest on,off Restart BGP if a fatal error occurs
bgp 0 allow_non_nets on,off
Default on
Advertise non-connected networks
bgp 0 debug 0-3 BGP Tracing