Digi TransPort WR31 - Related CLI Commands

Configure network services Network Services parameters
Digi TransPort WR Routers User Guide 348
Enable ZING
When enabled, the router uses the ZING protocol. ZING is a Digi-proprietary protocol for
configuring devices that do not have an IP address. ZING is no longer used.
Enable RCI over HTTP
When enabled, the router supports sending/receiving of Remote Command Interface (RCI)
requests over HTTP, through the embedded web server. The web server provides the
initialization, receiving, sending, and security for requests.
ASY O-n Listening Port
For the specified ASY port, sets the network port number on which to listen.
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
addp 0 enable on, off Enable Device Discovery (ADDP)
rport 0 enabled on, off Enable RealPort
rport 0 encryption on, off Enable Encrypted RealPort
snmp n v1enable 0, 1
0=Off
1=On
Enable Network Management Protocol > Enable
SNMP v1
snmp n port Default 161 Enable Network Management Protocol > UDP
Port n
snmp n v2cenable 0, 1
0=Off
1=On
Enable Network Management Protocol > SNMP
v2c
snmp n v3enable 0, 1
0=Off
1=On
Enable Network Management Protocol > Enable
SNMP v3
sntp 0 srvr_mode on, off Enable Simple Network Time Server (SNTP)
sntp 0 time_src 0=RTC
1=GPS
2=NTP Client
Enable Simple Network Time Server (SNTP) >
Source
services 0 SSH on, off Enable Secure Shell Server (SSH/SFTP)
services 0 ftp on, off Enable FTP Server
services 0 http on, off Enable HTTP Server
services 0 telnet on, off Enable Telnet Server