Configure legacy protocols Configure X.25 parameters
Digi TransPort WR Routers User Guide 551
General X.25 parameters
This section contains global X.25 settings.
When answering a X.25 call, use the addresses from CALL packet in the CALL CNF packet
If enabled, when answering a call, the X25 CALL CNF (call confirm packet) that the router sends
to answer the call use the called and calling addresses from the CALL packet. You can enable this
setting on a per-interface type basis, (LAPD, LAPB or XoT).
Reset XOT PVC if the router is the Initiator
If enabled, the router is responsible for resetting the links when an XOT PVC comes up. This
parameter should only be set to Off when it is known that the responder will reset the links.
Reset XOT PVC if the router is the Responder
If set to On, the router is responsible for resetting the links on XOT PVC links when it is the
responder. The default for this parameter is Off.
Include length of header in IP length header
For all X.25 calls that include an IP header length indication, such as IP Length Header is set to
On a TPAD or PAD, etc, this parameter specifies whether the length indicated includes or
excludes the length of the header itself. By default this setting is Off, in which case the length of
the header is NOT included in the value.
For example, suppose there is one byte of data of value 67 to encode. Then, 00 01 67 is the
encoding if this parameter is set to Off as the length (00 01) is 1, because the length does not
include the length of the header.
When set to On, the length of the IP header is included in the value, such as 00 03 67 is the
encoding as the header bytes are included.
To Next Page
Loading...
