Use the command-line interface Using the CLI parameter tables in this guide
Digi TransPort WR Routers User Guide 135
reboot command: reboot router
The reboot command reboots the router after altering the configuration. The reboot command
executes a complete hardware reset, loading and running the main image from cold. It has three
modes of operation:
▪ reboot: Reboots the router after any FLASH write operations have been completed. The
following operations allow 1 second to be completed before a reboot occurs:
• IPSec SA delete notifications are created and sent
• TCP sockets are closed
• PPP interfaces are disconnected
▪ reboot <n>: A time reboot; reboots the router in <n> minutes where n is 1 to 65535.
▪ reboot cancel: Cancels a timed reboot if entered before the time period has passed.
Reset the router to factory defaults
To reset router to factory defaults, see Reset the router to factory defaults.
Disable the reset button
Normally when the reset button is held in for 5 seconds the router is reset to factory defaults. You
can disable the factory reset button functionality, if required, and re-enable it as needed.
To disable the reset button, enter:
cmd 0 pbreset off
To re-enable the reset button functionality, enter:
cmd 0 pbreset on.
Note You can enable or disable the reset button from the web interface. For more information see
Reset the router to factory defaults.
To Next Page
Loading...
