Digi TransPort WR31 - CUD Mappings Parameters

Configure legacy protocols Configure Protocol Switch software
Digi TransPort WR Routers User Guide 609
CUD Mappings parameters
Protocol Switch CUD mappings allow you to map an incoming call’s CUD (call user data) from one
value to another. The PID (protocol identifier) portion of the CUD, if present, is maintained from
input to output and is not involved in the comparison.
The Configuration > Network > Protocol Switch > CUD Mappings web page displays a table with
four columns in which you can specify the CUD In values, corresponding CUD Out values and to
which interfaces the mappings should be applied. The interface field defines which output
interfaces this mapping applies to. Wildcard characters are allowed, and In each case the interface
type to which the mapping applies can be selected from ANY, LAPD, LAPB0, LAPB1, LAPB2, or XOT.
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
cudmap 0-9 cudfrom 0-65536 CUD In
cudmap 0-9 cudto 0-65536 CUD Out
cudmap 0-9 Interface 0, 1, 2, 3, 4, 12
0=Any
1=LAPD
2=LAPB 0
3=LAPB 1
4=XOT
12=LAPB 2
Interface