EasyManuals Logo

Digi TransPort WR31 User Manual

Digi TransPort WR31
866 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #258 background imageLoading...
Page #258 background image
Configure network interfaces Configure PSTN interfaces
Digi TransPort WR Routers User Guide 258
Advanced PSTN parameters
Metric
The route metric that should be applied to this interface. See PPP parameters for more detail.
Enable “Always On” mode of this interface
When enabled, causes the following two options to appear.
On/On and return to service immediately
Select whether the always-on functionality should simply be enabled or whether the additional
facility to return the interface to the In Service state should be applied.
Put this interface “Out of Service” when an always-on connection attempt fails
Normally, always-on interfaces do not go out of service unless they have connected at least
once. When enabled, causes the router to put the interface out of service even if the first
connection attempt fails.
Attempt to re-connect after s seconds
The length of time in seconds that the router should wait after an always-on PPP connection has
been terminated before trying to re-establish the link.
If an inhibited PPP interface is connected, attempt to re-connect after s seconds
The value in this text box takes precedence over the previous parameter when another PPP
instance that is usually inhibited by this one is connected. Use this parameter to reduce the
connection retry rate when a lower priority PPP instance is connected.
Wait s seconds after power-up before activating this interface
The initial delay that the router applies before activating the PPP instance after power-up. After
the initial power-up delay the normal always-on activation timers apply. If set to 0, no delay is
applied.
Control when this interface can connect using Time band n
These two controls, the check box and drop-down list, determine whether the time band
function should be applied to this interface. Enabling this setting enables the functionality and
the desired time band instance is selected from the drop-down list. See Configure time bands for
more information about the time band function.
Keep this interface up for at least s seconds
The minimum period that the PPP interface should remain available. This means that even if the
link becomes inactive before this period expires, the connection remains open.

Table of Contents

Other manuals for Digi TransPort WR31

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digi TransPort WR31 and is the answer not in the manual?

Digi TransPort WR31 Specifications

General IconGeneral
3GYes
4G-
2G standardsEDGE, GPRS
3G standardsHSPA+
GSM bands supported850, 900, 1800, 1900 MHz
UMTS bands supported850, 900, 1700, 1900, 2100 MHz
Antennas quantity2
Antenna connector typeSMA dipole
Security algorithmsHTTPS, SNMP, SNMPv3, SSH
USB 2.0 ports quantity1
Ethernet LAN data rates10, 100 Mbit/s
Ethernet LAN interface typeFast Ethernet
Product typeTabletop router
Product colorBlack
Housing materialAluminum
Output voltage9 - 30 V
Power source typeDC
Power consumption (typical)4 W
Storage temperature (T-T)-40 - 85 °C
Operating temperature (T-T)-34 - 74 °C
Operating relative humidity (H-H)5 - 95 %
WLAN data transfer rate (max)- Mbit/s
Weight and Dimensions IconWeight and Dimensions
Depth127 mm
Width89 mm
Height51 mm
Weight500 g

Related product manuals