Configure Virtual Private Networking (VPN) OpenVPN parameters
Digi TransPort WR Routers User Guide 463
OpenVPN n parameters
Description
The text string is a friendly name to help identify this OpenVPN instance.
Use
IP address a.b.c.d
This must be specified correctly. OpenVPN interfaces use a 30-bit mask. The first address is the
network address, the second address is the server address, the third address is the client
address, and the fourth address is the broadcast address. This address must be configured as
the second IP address in the block of four. For example, the IP address 192.168.0.1, if configured
as a server, or 192.168.0.2, if configured as a client.
Destination host a.b.c.d
Required only when the router is configured as an OpenVPN client. This is the IP address of the
OpenVPN server.
Link socket interface x,y
If configured, OpenVPN sockets are only allowed to/from this interface and the routing table will
be ignored. When set to Auto, the OpenVPN sockets use the routing table to identify the best
interface to use.
To Next Page
Loading...
