Configure legacy protocols Configure TPAD parameters
Digi TransPort WR Routers User Guide 546
Clear the call x seconds after receiving a response
The time period for which the socket closing or the X.25 call clearing is delayed by after the TPAD
session has finished. For example, if this parameter is set to 10, then 10 seconds after the TPAD
session is finished (NO CARRIER is seen on the ASY TPAD port) the network call (X25 or TCP
socket) is cleared. The number 1 is a special value. If set to the number 1, the call is cleared
immediately, instead of after 1 second.
If the terminal dial command specifies V.120 use PANS context x
This parameter is for advanced users only. It enables TPAD transactions to be carried out using
the V.120 protocol (ATDV command). Use this parameter with the Polling Answering Service
(PANS). It identifies which PANS instance to use for an outgoing V.120 call. For this to work, the
PANS instance must be bound to a Rate Adaption instance.
To Next Page
Loading...
