Digi TransPort WR31 - Page 548

Configure legacy protocols Configure TPAD parameters
Digi TransPort WR Routers User Guide 548
tpad n samecall 2 Allow concurrent transactions.
tpad n delimchar 32-127 Use ASCII character x as the
delimiter character.
tpad n ftime 0-20000 Forward mode time x milliseconds.
tpad n trig_str text Create an event when reply from
X.25 host matches.
tpad n IPaddr IP address Connect to remote IP address.
tpad n iphdr 0=Off
1=On
2=8583 Ascii 4 byte
IP length header.
tpad n termid text Use Terminal ID (TID).
tpad n dotermid 1=enabled, 0=disabled Replace TID provided by
connected terminal with
configured TID.
tpad n tid text Use TID xxxxxxxxx with incoming
APACS 50 polling calls.
tpad n merchnum text Use merchant Number.
tpad n useconstr 1=enabled, 0=disabled Use Connect String.
tpad n constr text Use Connect String.
tpad n pollchars text The polling character set is c.
tpad n domsgnb 1=enabled, 0=disabled Enable Message Numbering
tpad n disdir 1=enabled, 0=disabled Disable Direct Mode.
tpad n bdir 1=enabled, 0=disabled Boot to Direct Mode.
tpad n uaarc 0-99 Use response code n in unable to
authorise message.
tpad n clear_dirtime 0-60000 Clearing time n milliseconds.
tpad n trandel 0-5000 Delay transmitting the APACS 30
string for x milliseconds after
connecting to X.25 host.
tpad n teretran 1=enabled, 0=disabled Retransmit APACS 30 string if error
detected.
tpad n delstx 1=enabled, 0=disabled STX/ETX removal.
tpad n no_enq 1=enabled, 0=disabled Do not transmit ENQ characters.
Entity Instance Parameter Values Equivalent web parameter