Configure security settings User security settings
Digi TransPort WR Routers User Guide 681
User security settings
User system security setting
To configure system security settings, go to Configuration > Security> User.
The User parameter pages allow you to configure a number of authorized users. The number of
users available depends on the firmware build the router is running. Each user has a password and
access level that determines the facilities to which the user has access.
Username
The name of the user. Up to 14 characters are allowed. You can use some special usernames:
If a % symbol is part of the username, you must enter another % character as an escape
character. For example user%1 should be entered as user%%1.
Password / Confirm Password
The password for the user. Up to 14 characters are allowed.
Access Level
Selects the access level for the user. There are the following options:
Username Description
%s Uses the serial number of the router as the username.
%i Uses the IMEI of the cellular module as the username.
%c Uses the ICCID of the SIM as the username.
Access level Access allowed
Super Allows full access to all facilities.
High Allows user to reconfigure the general configuration of the router and to change
some settings such as the time and date.
Not allowed to change user settings.
Medium Allows user to access medium level configuration commands which allow some
configuration of the router.
Low Allows user to access low level commands which tend to be status and statistics
commands.
Read Only Read only access of the configuration.
None User is not allowed to login via Web, FTP, SSH, and Telnet.
To Next Page
Loading...
