Use the command-line interface AT commands
Digi TransPort WR Routers User Guide 120
System hierarchy of smib commands
The system hierarchy consists of the following:
at\smib=mib-2.system.sysdescr
This variable shows the software version information; equivalent to what is shown on the ati5
CLI command output.
mib-2.system.sysdescr =
Software Build Ver5121. Jan 31 2011 12:26:04 9W
at\smib=mib-2.system.sysobjectid
The authoritative identification of the network management subsystem. TransPort does not
support outputting OID variables. Instead, oid is output.
mib-2.system.sysobjectid = oid
at\smib=mib-2.system.sysuptime
The time the router has been running in 10msec units (hundredths of a second).
mib-2.system.sysuptime = 1806718
The above example shows that the router has been running for 5 hours, 1 minute and 7.18
seconds.
at\smib=mib-2.system.syscontact
A description of the contact person for the router. For TransPort, this is always a zero-length
string.
at\smib=mib-2.system.sysname
The name of the router. This is the name set in the Router Identity parameter on the
Configuration > System > Device Identity page.
mib-2.system.sysname = digi.router
at\smib=mib-2.system.syslocation
The physical location of the router. For TransPort, this is always a zero-length string.
To Next Page
Loading...
