Digi TransPort WR31 - Page 162

Configure network interfaces Configure Ethernet interfaces
Digi TransPort WR Routers User Guide 162
Use interface x,y over which to send probe
Overrides the routing code and forces the probe packets to be sent out of a specific interface.
Get the source IP address from interface x,y
Enables probe packets having the source IP address from a specific interface, rather than the
interface over which it is being transmitted.
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
eth n vrrpid 0-255 VRRP Group ID
eth n vrrpprio 0-255 VRRP Priority
eth n vboostprio 0-255 Boost the priority by n for s seconds after
switching to the MASTER state
eth n vboostsecs Integer Boost the priority by n for s seconds after
switching to the MASTER state
eth n vprobemode off, TCP,
ICMP
Send p probe to IP address a.b.c.d TCP port n
eth n vprobeip IP Address Send p probe to IP address a.b.c.d TCP port n
eth n vprobeport 0-65535 Send p probe to IP address a.b.c.d TCP port n
eth n vprobebackint 0-32767 every n seconds when in Backup state
eth n vprobemastint 0-32767 every n seconds when in Master state
eth n vprobeadj 0-255 Adjust priority n dir after x probe failures
eth n vprobeadjup 0=down
1=up
Adjust priority n dir after x probe failures
eth n vprobefailcnt 0-255 Adjust priority n dir after x probe failures
eth n vprobesuccesscnt 0-255 Reset probe failure count after n probe
successes
eth n vprobeent Auto, ETH,
PPP
Use interface x,y over which to send probe
eth n vprobeadd Integer Use interface x,y over which to send probe
eth n vprobeipent Auto, ETH,
PPP
Get the source IP address from interface x,y
eth n vprobeipadd Integer Get the source IP address from interface x,y