Digi TransPort WR31 - Page 192

Configure network interfaces Configure mobile (cellular) interfaces
Digi TransPort WR Routers User Guide 192
Mobile Network Settings CLI commands
Entity Instance Parameter Values Equivalent web parameter
ppp 1 do_nat 1 Enable NAT on this interface
IP Address
ppp 1 do_nat 2 Enable NAT on this interface
IP Address and Port
ppp 1 ipsec 1 Enable IPsec on this interface
ppp 1 ipsec 2 Keep Security Associations (SAs) when this
Mobile interface is disconnected
ppp 1 ipsecent blank,ETH,PPP Use interface X, Y for the source IP address
of IPsec packets
x=Interface type
ppp 1 ipsecadd 0-255 Use interface X, Y for the source IP address
of IPsec packets
y=interface number
ppp 1 firewall off, on Enable the firewall on this interface