EasyManua.ls Logo

Digi TransPort WR31 - Page 241

Digi TransPort WR31
866 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configure network interfaces Configure ISDN interfaces
Digi TransPort WR Routers User Guide 241
ppp n l_addr off, on
When on, allows
negotiation
When off, forces
use of specified IP
address
Use a.b.c.d as the local IP address of this
router
ppp n DNSserver Valid IP address
a.b.c.d
Use the following DNS servers if not
negotiated
Primary DNS server a.b.c.d
ppp n secDNS Valid IP address
a.b.c.d
Use the following DNS servers if not
negotiated
Secondary DNS server a.b.c.d
ppp n IPmin Valid IP address
a.b.c.d
Assign remote IP addresses from a.b.c.d to
a.b.c.d
ppp n IPrange 0-255 Assign remote IP addresses from a.b.c.d to
a.b.c.d
ppp n transDNS Valid IP address
a.b.c.d
Primary DNS server a.b.c.d
ppp n sectransDNS Valid IP address
a.b.c.d
Secondary DNS server a.b.c.d
ppp n ans off, on Allow this PPP interface to answer incoming
calls
ppp n cingnb up to 25 digits Only allow calling numbers ending with n
ppp n do_nat 0, 1, 2
0=Disabled
1=IP address
2=IP address and
port
Enable NAT on this interface
IP address/IP address and Port
ppp n nat_ip Valid IP address
a.b.c.d
NAT Source IP address a.b.c.d
ppp n ipsec 0=Disabled
1=Enabled
2=Enabled and
Keep SAs
Enable IPsec on this interface/
Keep Security Associations when this ISDN
interface is disconnected
ppp n firewall off, on Enable the firewall on this interface
Entity Instance Parameter Values Equivalent web parameter

Table of Contents

Other manuals for Digi TransPort WR31

Related product manuals