Digi TransPort WR31 - Page 441

Configure Virtual Private Networking (VPN) IPsec parameters
Digi TransPort WR Routers User Guide 441
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
ike n retranint 0-255 Retransmit a frame if no response after n
seconds
ike n retran 0-9 Stop IKE negotiation after n retransmissions
ike n inactto 0-255 Stop IKE negotiation if no packet received for
n seconds
ike n dpd on, off Enable Dead Peer Detection
ike n natt on, off Enable NAT-Traversal
ike n initialcontact on, off Send INITIAL-CONTACT notifications
ike n keepph1 on, off Retain phase 1 SA after failed phase 2
negotiation
ike n privrsakey Filename RSA private key file
ike n delmode 0=Normal
1=Remove IKE SA
when last IPsec SA
removed
2=Remove IPsec SAs
when IKE SA remove
3=Both
SA Removal Mode
ike n openswan on, off None. This enables support for Openswan
IKE implementations.