Digi TransPort WR31 - Page 461

Configure Virtual Private Networking (VPN) PPTP parameters
Digi TransPort WR Routers User Guide 461
Enable Socket mode
When enabled, enables the use of a Digi proprietary mode whereby PPP packets are sent via the
PPTP control socket rather than in GRE packets.
Encrypt control data using SSL version n
When enabled, the router encrypts the control data using SSL. This is a Digi proprietary function
and is not part of standard PPTP. The drop-down list allows the SSL version to be selected. The
available options are:
• Use default
• TLSv1 only
• SSLv2 only
Enable PPTP debug
When enabled, enables debug tracing.
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
pptp 0-9 name Up to 30 characters Description
pptp 0-9 remhost Valid IP address a.b.c.d Remote Host a.b.c.d
pptp 0-9 ll_ent Blank, PPP, ETH
Blank means Auto
Use Interface x,y
pptp 0-9 ll_add 0-4294967296 Use Interface x,y
pptp 0-9 listen off, on Accept incoming PPTP connections
pptp 0-9 swap_io off, on Enable Server mode
pptp 0-9 usesock off, on Enable Socket mode
pptp 0-9 sslver Blank,SSL,TLS1,SSL2
Blank is disabled
(default)
SSL means use default.
Encrypt control data using SSL version n
pptp 0-9 debug off, on Enable PPTP debug