Digi TransPort WR31 - Page 486

Configure Secure Shell (SSH) server and client Configure Secure Shell (SSH) Client
Digi TransPort WR Routers User Guide 486
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
sshcli 0-7 conn_to 0-10 seconds Time in seconds to wait for the server to
begin the banner exchange part of the
protocol after the socket connects.
sshcli 0-7 hostsfile Up to 12 characters (8.3
format)
Key file to use as the regular SSH client.
sshcli 0-7 idfile Up to 12 characters (8.3
format)
Key file to use as the regular SSH client.
sshcli 0-7 idrsafile Up to 12 characters (8.3
format)
Name of either an SSH V1 or SSH V2 host key.
sshcli 0-7 idrsafile1 Up to 12 characters (8.3
format)
Name of either an SSH V1 or SSH V2 host key.
sshcli 0-7 comp 0=disabled Use Deflate compression, level.
sshcli 0-7 pubkeyauth 0=disabled Enables SSH public-key authentication to
connect to OpenSSH.
sshcli 0-7 pwdauth 0=disabled Enables SSH password authentication to
connect to OpenSSH.
sshcli 0-7 enc3descbc 0-2147483647
0=Disabled
3DES.
sshcli 0-7 encaes128cbc 0-2147483647 AES (128 bits).
sshcli 0-7 encaes192cbc 0-2147483647 AES (192 bits).
sshcli 0-7 encaes256cbc 0-2147483647 AES (256 bits).
sshcli 0-7 macmd5 0-2147483647 MAC MD5.
sshcli 0-7 macmd596 0-2147483647 MAC MD5-96.
sshcli 0-7 macsha1 0-2147483647 MAC SHA1.
sshcli 0-7 macsha196 0-2147483647 MAC SHA1-96.
sshcli 0-7 svrlaliveint 0-2147483647 Interval in seconds to send the server a
keepalive packet.
sshcli 0-7 svralivemax number Maximum number of keepalives to send
without response before the connection is
killed
sshcli 0-7 debug 0, 1
0=Off
1=On
Enable Debug