Configure Quality of Service (QoS) DSCP Mappings parameters
Digi TransPort WR Routers User Guide 507
Examples
▪ To display a DSCP mapping from the command line, type the following:
dscp <code> ?
Where <code> is a valid DSCP code from 0 to 63, or 64 (see note below).
▪ To change the value of a parameter, use the following command:
dscp <code> q <value>
Where <code> is a valid DSCP code and <value> is from 0 to 9.
▪ To set the default mapping value, enter the command:
dscp 64 q <value>
Where <value> is the default queue number required and has a value from 0 to 9.
Note DSCP code 64 is not actually a valid code, but is employed here to set up the default priority.
To Next Page
Loading...
