Digi TransPort WR31 - Page 534

Configure legacy protocols Configure Systems Network Architecture over IP (SNAIP)
Digi TransPort WR Routers User Guide 534
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
snaip x l1iface ISDN, Port,
SharedPort
Send SNAIP traffic over interface.
snaip x l1nb 0–255 (Select LAPB, Port
or SharePort instance)
Send SNAIP traffic over interface.
snaip x protocol LAPB, SNA, RAW,
RAW_NOHDR
Use the specified protocol.
snaip x ans 1=enabled,
0=disabled
Allow this unit to answer calls.
snaip x msn text Only accept calls with MSN ending with
the specified text.
snaip x sub text Only accept calls with sub-address
ending with the specified text.
snaip x autocontact 1=enabled,
0=disabled
Assume station exists. (Do not send
TEST frames).
snaip x dcd_toggle 1=enabled,
0=disabled
Toggle DCD output each time the DLSw
protocol enters the DISCONNECTED
state.
snaip x l1oos 1=enabled,
0=disabled
Sync port should not send or receive
data when WAN link is down.
snaip x master 1=enabled,
0=disabled
Router to be Master on an unbalanced
link.
snaip x pollresp 0-2147483647 Polling Response Time.
snaip x stations text Polling Stations Addresses.
snaip x saps text SAPs.
snaip x dsaps text DSAPs(blank=default).
snaip x send_xid_null 1=enabled,
0=disabled
Send Null XID (XID with no Data).
snaip x xid_data text Send XID with Data.
snaip x turntxtim 0-2147483647 Tx Turn Around Time.
snaip x dtemode 1=DTE, 0=DCD Mode.
snaip x n400 0-255 N400 counter.
snaip x tnoact 1000-60000 RR Timer.