Digi TransPort WR31 - Page 557

Configure legacy protocols Configure X.25 parameters
Digi TransPort WR Routers User Guide 557
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
lapb n l1iface port, isdn (use port for
sync port)
Use: Serial port Port x (in Synchronous Mode)
lapb n l1nb 0, 1 Use: Serial port Port x (in Synchronous Mode)
0 for Port 0, 1 for Port 1
lapb n l1iface port, isdn (use isdn for
ISDN)
Use: ISDN
lapb n dtemode DTE/DCE mode:
0=DTE
1=DCE
Mode DTE or DCE
lapb n N400 1-255 N400 Counter x
lapb n tnoact 1000-60000 RR Timer x milliseconds
lapb n t1time 1-60000 T1 Timer x milliseconds
lapb n t200 1-60000 T200 Timer x milliseconds
lapb n Window 1-7 X.25 Window Size
lapb n tinactx25 0-3000 Disconnect link if there has been no X.25 activity
for x seconds
lapb n tinact 0-3000 Disconnect link if there has been no activity for x
seconds
lapb n restartact 1=enabled
0=disabled
Send X.25 Restart packet on receipt of SABM
frame
lapb n ans 1=enabled
0=disabled
Allow this unit to answer calls
lapb n msn text Only accept calls from calling number ending with
lapb n sub text Only accept calls with sub-address ending with
lapb n ptime 0-60000 Wait x milliseconds before attempting to establish
the LAPB link after B-channel becoming active
lapb n cli text Only answer calls from numbers whose trailing
digits match
lapb n mux_0710 1=enabled
0=disabled
Mux 0710 mode
lapb n mux_mode 0=Basic
1=Error Recovery
Mux mode
lapb n dlc 0-63 DLC #