Configure legacy protocols Configure X.25 parameters
Digi TransPort WR Routers User Guide 580
Remote IP address
The IP address for outgoing XOT calls.
Use the source IP address from interface x,y
Which Ethernet or PPP interface to use for the source IP address.
Initiator interface
The name of the interface from which the PVC was initiated, such as Serial 1. The initiator and
responder strings identify the circuit when PVCs are being set up. They must match the names in
the remote router that terminates the XOT PVC connection. If the unit terminating the PVC XOT
connection is not another Digi router, you must refer to the documentation or the configuration
files of the other unit to determine the names of the interfaces.
Responder interface
The name of the interface to which a PVC initiator is connected, such as Serial 2.
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
pvc n l2iface Blank or lapb, lapd, tcp Enable this PVC
pvc n lcn 0-4096 LCN
pvc n uliface pad, tpad, xsw Connect this PVC to PAD x
pvc n psize 0=default
4=16
5=32
6=64
7=128
8=256
9=512
10=1024
Use packet size
pvc n window 1-7 Use window size
pvc n ipaddr IP address Remote IP address
pvc n srcipent auto, eth, ppp Use the source IP address from interface x,y
pvc n srcipadd 0-255 Use the source IP address from interface x,y
pvc n iniface text Initiator interface
pvc n respiface text Responder interface
To Next Page
Loading...
