Digi TransPort WR31 - Page 660

Configure system settings General system parameters
Digi TransPort WR Routers User Guide 660
W-WAN LED to display W-WAN, ISDN/PSTN
On the front panel of the display of models fitted with a W-WAN module, is an LED that you can
use to display the status of the W-WAN module or the status of the PSTN/ISDN connection. Use
the drop-down selection box to choose what the LED displays. The ISDN/PSTN settings depend
upon which of these two options are available on the router.
Serial LED to display Connection, DTR
On the front panel of the router is an LED dedicated to indicating the status of various signals on
the asynchronous serial line. Use the drop-down selection box to choose which signal status to
display. On modules fitted with W-WAN, this LED has additional functionality, you can use this
LED to display the W-WAN signal strength.
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
config n powerup 0, 1 Use Config n when the router powers up
cmd n anonftp 0, 1
0=Off (default)
1=On
Allow anonymous FTP login
snmp n ftpnatport 0-65535 Additional FTP NAT port
snmp n ent_nb 0-65535 SNMP Enterprise Number
Default 16378
cmd n ent_name Free text field SNMP Enterprise Name
cmd n dnsname Valid Domain name,
such as
mydomain.org
Only resolve DNS request for domain
cmd n gprsled_mode 0, 1 W-WAN LED to display W-WAN, ISDN/PSTN
0=W-WAN
1=ISDN/PSTN
cmd n asyled_mode 0, 1 Serial LED to display Connection, DTR
0=Connection
1=DTR status
2=W-WAN signal strength