Configure security settings User security settings
Digi TransPort WR Routers User Guide 684
Remote Peer IP subnet
If multiple PPP interfaces are enabled for answering and multiple remote routers can dial into
the local router, the router cannot always use static routes cannot to ensure that packets which
should be routed to the remote network are sent through the correct PPP interface. Use this
parameter with the Remote Peer IP subnet mask parameter to associate a network subnet
with a user. When a remote unit connects in and authenticates with the router, the router
creates a dynamic route that will override any static routes for the duration of the PPP session.
The interface for the dynamic route is the PPP interface that answered the call. The network
address for the dynamic route comes from the entry in the user table matching the username
the remote unit used during PPP authentication.
Remote Peer IP subnet mask
The remote subnet mask parameter. Use with the Remote Peer IP subnet parameter above to
fully qualify the network address for the user.
Public Key file
The name of the file containing the public key for that user. If the public key matches the client
supplied public key, the user is allowed access.
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
user 0 dun_en on, off Allow this user to log in over a PPP network
user 0 phonenum Number Use this number x when PPP dial-back is required
for this user
user 0 newpwd String
(up to 14 chars)
Alternate IKE Key
user 0 fieldip IP Address Remote Peer IP address
user 0 ipaddr IP Address Remote Peer IP subnet
user 0 mask IP Mask Remote Peer IP subnet mask
user 0 keyfile Filename Public Key file
To Next Page
Loading...
