Digi TransPort WR31 - Page 779

Manage networks and connections View network interface status
Digi TransPort WR Routers User Guide 774
Protocol
The protocol that created the route. This setting can be one of the following:
Idx
Used for static routes only. The index of the configured static route.
Interface
The interface over which the IP packet will be routed when using the route.
Status
The current status of the route. This setting can be one of the following:
Related CLI commands
Setting Description
Local The route is for a network connected directly to the router.
Remote The route is for a remote network accessed via a PPP connection.
Static The route is a static route.
Static/RIP The route is a static route that has been updated by RIP.
RIP The route is a RIP route.
IBGP The route is an interior BGP route.
EBGP The route is an exterior BGP route.
OSPF The route is an OSPF route.
Setting Description
UP The route is up and is ready for use in routing.
DOWN The interface that the route uses is currently down. The interface can be
activated if the route is required.
OOS The interface that the route uses is currently “Out of Service”.
Command Options Action
route print Displays the IPv4 routing table.
route printsrc Displays the IPv4 routing table with the src addr information.