Hardware TransPort WR44 / WR44 R hardware
Digi TransPort WR Routers User Guide 78
4ISDN: Provides an ISDN Basic Rate Interface (BRI) via an RJ45 port. This can be configured either
as a TE (terminal endpoint) or as NT-1 (network termination). The option also includes an
additional asynchronous serial port via a second RJ45 port.
5 Telemetry 1 I/O interface: Provides 4 opto-isolated digital input ports and 1 opto-isolated
digital output port. It also provides a relay I/O port, a voltage monitoring port, and internal
temperature monitoring.
6 Telemetry 2 I/O interface: Provides 4 isolated analog I/O ports and 4 non-isolated digital I/O
ports.
7Fleet I/O interface: Provides CAN and J1708 interface, GPS, 4 non-isolated digital I/O ports,
ignition sense port, and a 3 axis accelerometer.
8PSTN: Provides a PSTN interface via an RJ45 connector for dialing out and receiving calls.
9ISDN-U/PSTN: Provides an ISDN-U interface suitable for the USA plus PSTN interface. It can be
configured for Bell-103 modulation in leased line mode as well as a normal PSTN interface.
10 DialServ: This RJ11/FXS connection converts a PSTN analog modem to a RS-232 serial signal.
For more information on the Telemetry 1, Telemetry 2, and the Fleet I/O Interfaces please see the
product specific user’s guides, available on www.digi.com on the TransPort WR44 product
Resources page.
To Next Page
Loading...
