● Target selection may be delayed or
disturbed when the vehicle is entering and
exiting curves. The ICA system may not
work or operate too late in these cases.
● The ICA system is suitable for driving on
expressways and good roads, but not on
complicated urban roads or mountain
roads.
● If the vehicle is too close to vehicles in
adjacent lanes (or vehicles in adjacent
lanes are too close to the vehicle's lane),
it is possible that the system reacts to
adjacent vehicles and performs braking.
● If a vehicle changes lanes into the driving
path of the vehicle and is within the
detection range of ICA system, when it is
identified as the target vehicle, the system
may react to it, which may lead to forced
braking or untimely braking. The driver
should take over the vehicle control in
time to avoid traffic accidents.
● When the vehicle overlaps too closely
with the front vehicle, the ICA system
cannot identify the front vehicle as the
target vehicle, so the driver needs to
maintain control of the vehicle.
● In case of influence by the environment
(such as heavy rain) or due to the
characteristics of the target, the
monitoring function of radar and camera
sensors will be interfered and the
performance will be degraded.
● It is forbidden to change the positions of
the radar and front camera without
authorization.
● The ICA system only reacts to moving
vehicles in the same direction or
stationary vehicles ahead, and does not
react to oncoming vehicles or crossing
vehicles.
● When following a vehicle ahead to a stop,
in rare cases the system will not
recognize the end of the vehicle ahead
but the lower end of the target (such as
the rear axle of a truck with a high chassis
or the bumper of a vehicle). The system
will not guarantee a proper stop distance
and the driver must remain alert and be
ready to brake at all times.
● Because of physical limitations, the ICA
system can not guarantee safe and
reliable operation under any
circumstances. If you have any question
about this function, please contact an
authorized dealer.
● Dirty or covered sensors will cause limited
functions. Do not cover the detection area
of sensors. Carefully clean the sensors if
necessary. Keep the windshield clean.
● When the vehicle is in road sections with
complicated lanes (intersection/suddenly
changed lane markings/converging lane
markings, etc.), the lane information may
not be detected for a short time. Please
maintain control of the vehicle.
● The ICA function will keep the vehicle at
the center between lane markings. Please
turn off or turn on the turn signal lamps to
suppress this function in special
circumstances (such as overtaking a
truck).
● During driving on congested roads, in
windy areas, on winding or steep roads,
or on slippery roads such as rainy, snowy
or icy roads, do not activate the ICA
system, for fear of an accident due to loss
of control of the vehicle.
● Do not use the ICA system when driving
in no-road or non-road sections. This
function is only suitable for hard roads
paved on the road, otherwise it will cause
an accident.
To Next Page
Loading...