Adjustment before driving
Preparation before driving
For better use of the A/C, please use the operation methods recommended in the table below in a reasonable manner.
Recirculation/fresh
air mode
First recirculation
and then fresh air
Adjust the A/C temperature
to a low value
Adjust the fan speed of the
A/C to a high position
When the compressor is
working, it consumes part
of the engine power, so
there is a loss of engine
power.
First recirculation
and then fresh air
Adjust the A/C temperature
to a high value
Adjust the fan speed of the
A/C to a high position
The heater heats the air
through the engine coolant,
so the heated air can only
be blown out after the
engine has been running
for a while.
Adjust the A/C temperature
to the lowest value
Adjust the fan speed of the
A/C to a high position
The fresh air from outside
can be blown into the
vehicle. The air volume can
be adjusted according to
the comfort level.
Front
windshield
interior
defogging
Select the front windshield
defogger/air outlet mode
Adjust the A/C temperature
to the lowest value
Adjust the fan speed of the
A/C to a high position
When fogging appears on
the front windshield, it will
affect the driver's sight,
causing a safety hazard.
Front
windshield
exterior
defogging
Select the front windshield
defogger/air outlet mode
Adjust the A/C temperature
to a high value
Adjust the fan speed of the
A/C to a high position
The temperature can be
set to the highest position
for quick defrosting. The
button can be used
to defog/defrost the rear
windshield.
Select the floor + front
windshield defogger/air
outlet mode
Adjust the A/C temperature
to the lowest value
Adjust the fan speed of the
A/C to the minimum
position
After the setting is
completed, press the A/C
OFF button to deactivate
the system.