DongFeng Huge - Page 69

Adjustment before driving
- 69 -
Preparation before driving
1
Adjustment of A/C system
Manual mode
Manually adjust the air outlet mode, air volume,
temperature, recirculation/fresh air, front/rear
windshield defogger/defroster, etc. to meet the
comfort requirements.
Turning on/off A/C system
ON
When the A/C system is off, you can turn it on by
pressing the button, button, fan
speed control button, front windshield defogger
button, or air outlet mode button.
Press the front windshield defogger button to
enable the A/C to enter the front windshield
defogging mode directly, and press the button
again to turn off the system.
Off
When the A/C system is on, you can turn it off by
pressing the A/C OFF button .
Temperature control
Slide the temperature control button on the
control panel upward or touch the temperature
up button on the MP5 display to increase the
temperature; slide the temperature control button
on the control panel downward or touch the
temperature down button on the MP5 display to
reduce the temperature.
In the case that the temperature inside the
vehicle is high and needs to be cooled off, the
A/C will work only when the button is
pressed with the engine running.
Air volume control
When the A/C is turned off, slide the fan speed
control button on the control panel upward or
touch the fan speed up button on the MP5
display to start the A/C system. When the A/C is
turned on, slide the fan speed control button on
the control panel or touch the fan speed button
on the MP5 display to adjust the fan speed.
There are 8 fan speed positions. Slide the fan
speed control button on the control panel
upwards or touch the fan speed up button on the
MP5 display to increase the fan speed; slide the
fan speed control button on the control panel
downward or touch the fan speed down button
on the MP5 display to reduce the fan speed.
Switching fresh air/ recirculation mode
Press the recirculation mode button on
the control panel, so the indicator lamp above
the button comes on, or touch the recirculation
mode button on the MP5 display, so the
button is highlighted, indicating that the
recirculation mode is enabled.
Press the fresh air mode button on the
control panel, so the indicator lamp above the
button comes on, or touch the fresh air mode
button on the MP5 display, so the button
is highlighted, indicating that the fresh air mode
is enabled.