125
c Platemaking/Master Feed and Ejection Section
chap.3
440063
(1)
Removal of Master Clump Opening / Closing Unit
1) Remove the rear cover.
2) Remove the drum.
3) Move the position of the master clump opening /
closing lever to the mode other than B mode.
(Use the HELP 02)
HELP mode H-02 \ see p.221
\See page 110
4) Pull out 3 connectors.
5) Remove the sub-frame C.
6) Remove 3 screws to take out the opening / closing
unit.
\See page 132
1) Remove the master clump opening / closing unit.
2) Loosen the set screw to remove the gear.
3) Remove 3 screws to take out the motor.
Set screw
Screws
Screw
(2) Removal of Clump Motor
Master Clump opening/Closing Section
440062
Screws
Connector
Pull out connector
Screw
Master clump
opening / closing unit
Clump motor
Pull out connector
To Next Page
Loading...
