Duplo DUPRINTER DP-430 User Manual

146
Chapter 4 Standards / Adjustment
z Scanner Section.........................................................148
(1) Attaching the Rear Wire ......................................148
(2) Attaching the Front Wire.....................................149
x Platemaking / Master Feed / Ejection Section.........150
Platemaking /
Master Feed Section
......................150
(1) Adjusting the Timing Belt Tension......................150
(2) Position Adjustment of Thermal
Head Up/Down Motor..........................................150
Master Ejection Section .........................................151
(1) Attaching the Spring............................................151
(2) Adjusting the Timing Belt Tension......................152
Master Clump opening/Closing Section ..............153
(1) Adjusting the Timing Belt Tension......................153
(2) Positioning the Master Clump
Opening / Closing Levers.....................................153
(3) Adjusting the A / B / C Modes..............................154
c Paper Feed Section ...................................................158
(1) Adjusting the Paper Separator
Unit Clearance.....................................................158
(2) Adjusting the Paper Separation Pressure...........159
(3) Adjusting the Elevator Top Limit Sensor............159
(4) Adjusting the Elevator Bottom Limit Switch .....160
(5) Adjusting the Double Feed Detection Sensors....161
(6) Adjusting the G Roll Escape
Amount / Timing...................................................161
(7) Adjusting the Top/Bottom Position Sensors........162
v Drum Driving Section................................................163
(1) Adjusting the Drum Stop Position.......................163
(2) Adjusting the Master Set / Removal Position ..... 164
b Press Section ............................................................165
(1) Adjusting the P-Roller Sensor .............................165
(2) Adjusting the Printing Area
(Press OFF Timing)
................................................... 166
n Paper Ejection Section.............................................167
(1) Adjusting the Paper Stripper
Finger Clearance..................................................167
(2) Adjusting the Paper Stripper
Finger Return Stopper..........................................168
m Drum Section .............................................................169
(1) Adjusting the Ink Amount...................................169
(2) Adjusting the Squeegee Gap................................170
(3) Adjusting the Master Clump ...............................171
(4) Adjusting the Master Clump Section..................171
(5) Adjusting the Drum Rail Gap..............................172

Duplo DUPRINTER DP-430 Specifications

General

Brand	Duplo
Model	DUPRINTER DP-430
Category	Printer
Language	English