213
c HELP Mode Function and Operation Procedures
chap.7
c HELP Mode Functions and Operation Procedures
(1)
Accessing HELP Modes
(2) Guide to the HELP Mode Descriptions
q
During use of the DUPRINTER: first put the machine into the
standby state, then turn the Power switch OFF.
wSimultaneously press and hold down the and PRINTING
SPEED ADJUSTMENT keys, and turn the Power switch ON with
those keys held down. After about 2 seconds, a beep-beep-beep
tone will sound, and the HELP mode display will appear.
eUsing the numeric keys, enter the number of the HELP mode you
want to access.
Example: To access HELP mode H-11, enter [1], [1].
¡Alternatively, the and PRINTING SPEED ADJUSTMENT
keys
may be used to select the HELP mode number.
rPress the PRINT key. The HELP mode specified in
e
will be
accessed.
From this point on, follow the procedure given below for the
particular mode accessed.
The descriptions of each HELP mode given on the following pages
are laid out as follows:
References
to related
pages
LC display
for function
Operation
procedure for
individual
functions
Main functions
NOTE :
H-03
(1)Function testingHELP mode
(1)
Clutch function testing, Auto power off, Thermal head's
power source/ signal
¡Following items are tested.
1. Signal solenoid master feed clutch
2. Auto power off
3. Thermal head power source
2. Operation procedure
Accessing HELP modes
a
See page 000
(1) Testing the clutch's functioning, Auto power off,
Thermal head's power source/ signal
qAccess HELP mode H-03, and press the PRINT key.
wPress the and/or key to select the item.
Mode number
Ex : enter 1, 1, PRINT key
Mode number flashes
References
to related
pages
Function categoryHELP mode number
To Next Page
Loading...
Need help?
General