n Operation Procedures
chap.1
27
2. Multiple Image Printing / 2 IN 1 Layout Mode
In the normal state (when the ADF is not connected) the
mode is switched by pressing the multiple printing
selection key as follows.
Each press of the multiple printing selection key
makes a different multiple printing indicator
light up, in sequence.
To set the number of images, press the key until
the indicator for the desired number of images
is lit.
NOTE :
When the ADF is connected, the multiple printing selection
key can also be used to select the 2 in 1 Layout Mode, as
shown below.
To activate the 2 in 1 Layout Mode, press the key until the
" " icon is lit.
To Next Page
Loading...
Need help?
General