HELP
Description
Classification
page
H-00
(1) Display of ROM versions(Main,P-memory,ADF,I/F PCB unit)
(2) ROM version upgrading (Main PCB unit)
(3) ROM version upgrading (P-memory PCB unit)
(1) 214
(2) 215
(3) 216
(1) 228
(2) 229
H-01
(1) 217
(2) 218
(3) 218
(4) 219
(5) 219
(6) 220
(7) 220
H-02 221
H-03 222
H-04 223
H-05
224
H-06
(1) Sensor condition checking 2
226
H-07
H-08
230
H-09 231
232
H-10
H-11
H-12
234
235
H-13
(1) Speed check(Pre-stop,JOG,Print speed,Eject fan speed)
(2) Pre-stop speed adjustment
(3) JOG speed adjustment
(4) Print speeds adjustment
(5) Initialization of print speeds
(6) Eject fan speeds adjustment
(7) Initialization of eject fan speeds
(1) Motor function testing
(1) Function testing : Signal solenoid
Auto power OFF
Thermal head’s power source/ signal
Paper feed clutch
(1) Ink supply/circulation testing
(1) Sensor condition checking 1
(1) Condition checking/Adjusting : End mark sensor
(2) Condition checking/Adjusting : Master detection sensor
(1) Switch condition checking
(1) Position check : Master set position
JAM position
Master removal position
Drum stop position
(1) Function testing : Lamp(ON/OFF)
Motor(Scanner/ADF)
(1) Checking : Document size
Document density level
(1) Checking : Shading memory
Synchronous signal
Temperature
Time elapsed from the last printing
(1) Setting : Master ejection counter
Master making counter
Factory adjustment
Mode No.
ROM version
displays / upgrading
Adjustment/specification
Function test
Function test
Function test
237
(1) Checking : Movement amount of printing position(top/bottom)
Function test
Sensor condition display
Sensor condition display
Sensor condition
display / adjustment
Switch condition display
Function test
Function test
Function test
Function test
Adjustment/specification
H-14
(1) 236
(2) 236
H-16
238
239
240
H-15
(1) Master total counter display
(2) Resetting of count of total plates made in user mode
(1)
Master-making start position (Online) setting [ Parallel / Inter face kit 2 ]
Total counts
H-17
(1) Setting : Pre-platemaking slider operation enable/disable
Thick paper feed setting
Editing setting
H-18
(1) Checking of number of error occurrences
Adjustment/specification
Adjustment/specification
Adjustment/specification
233
To Next Page
Loading...
Need help?
General