ePress the [=] key.
The correction amount will be memorized in the battery PCB unit's
EEPROM. During memorization,"SAVE" will be displayed.
Do not turn off the power before the "SAVE" display has disappeared.
1. Functions
(1)
Initial print density, Initial master density,Initial document
mode,Initial print speed setting
¡Following items are indicated.
A : Initial print density
B : Initial master density
C : Initial document mode
D : Initial print speed
(1)
Initial print density, Initial master density,Initial document
mode,Initial print speed setting
¡During memorization:
IMPORTANT :
2. Operation procedure
Accessing HELP modes
a
See page 213
qAccess HELP mode H-74, and press the PRINT key.
wUse the [0] and [1] numeric keys to enter a 4-place binary
value for the desired correction amount.
See the table below for 4-place binary values and the corresponding
correction amounts.
a
To exit the HELP mode
: Turn the power switch OFF.
a
To access another HELP mode
:
Enter the desired mode number
using the numeric keys.
rPress the STOP key.
The HELP mode selection display will reappear.
- SAVE -
A B C D A B C D
Print speedMaster densitiy
Print densitiy
Document mode