C
HAPTER
5
| Interface Configuration
Saving Power
– 149 –
PARAMETERS
These parameters are displayed:
◆ Port – Power saving mode only applies to the Gigabit Ethernet ports
using copper media.
◆ Power Saving Status – Adjusts the power provided to ports based on
the length of the cable used to connect to other devices. Only sufficient
power is used to maintain connection requirements. (Default: Enabled
on Gigabit Ethernet RJ-45 ports)
WEB INTERFACE
To enabl e power s av i n g s :
1. Click Interface, Green Ethernet.
2. Mark the Enabled check box for a port.
3. Click Apply.
Figure 52: Enabling Power Savings
To Next Page
Loading...
Need help?
General