C
HAPTER
7
| Address Table Settings
Configuring MAC Address Learning
– 186 –
â—† Also note that MAC address learning cannot be disabled if any of the
following conditions exist:
â–
802.1X Port Authentication has been globally enabled on the switch
(see "Configuring 802.1X Global Settings" on page 326).
â–
Security Status (see "Configuring Port Security" on page 323) is
enabled on the same interface.
PARAMETERS
These parameters are displayed:
◆ Interface – Displays a list of ports or trunks.
◆ Port – Port Identifier. (Range: 1-10)
◆ Trunk – Trunk Identifier. (Range: 1-5)
◆ Status – The status of MAC address learning. (Default: Enabled)
WEB INTERFACE
To enable or disable MAC address learning:
1. Click MAC Address, Learning Status.
2. Set the learning status for any interface.
3. Click Apply.
Figure 82: Configuring MAC Address Learning
To Next Page
Loading...
Need help?
General