Edge-Core ES3510MA - Page 33

F IGURES
– 33 –
Figure 68: Showing the Members of a Dynamic VLAN 168
Figure 69: QinQ Operational Concept 169
Figure 70: Enabling QinQ Tunneling 173
Figure 71: Adding an Interface to a QinQ Tunnel 174
Figure 72: Configuring Protocol VLANs 176
Figure 73: Displaying Protocol VLANs 176
Figure 74: Assigning Interfaces to Protocol VLANs 178
Figure 75: Showing the Interface to Protocol Group Mapping 178
Figure 76: Configuring IP Subnet VLANs 180
Figure 77: Showing IP Subnet VLANs 180
Figure 78: Configuring MAC-Based VLANs 182
Figure 79: Showing MAC-Based VLANs 182
Figure 80: Configuring VLAN Mirroring 184
Figure 81: Showing the VLANs to Mirror 184
Figure 82: Configuring MAC Address Learning 186
Figure 83: Configuring Static MAC Addresses 188
Figure 84: Displaying Static MAC Addresses 188
Figure 85: Setting the Address Aging Time 189
Figure 86: Displaying the Dynamic MAC Address Table 190
Figure 87: Clearing Entries in the Dynamic MAC Address Table 191
Figure 88: Mirroring Packets Based on the Source MAC Address 192
Figure 89: Showing the Source MAC Addresses to Mirror 192
Figure 90: STP Root Ports and Designated Ports 193
Figure 91: MSTP Region, Internal Spanning Tree, Multiple Spanning Tree 194
Figure 92: Common Internal Spanning Tree, Common Spanning Tree,
Internal Spanning Tree 195
Figure 93: Configuring Port Loopback Detection 197
Figure 94: Configuring Global Settings for STA (STP) 200
Figure 95: Configuring Global Settings for STA (RSTP) 201
Figure 96: Configuring Global Settings for STA (MSTP) 201
Figure 97: Displaying Global Settings for STA 203
Figure 98: Configuring Interface Settings for STA 206
Figure 99: STA Port Roles 208
Figure 100: Displaying Interface Settings for STA 209
Figure 101: Creating an MST Instance 211
Figure 102: Displaying STA Settings for an MST Instance 211
Figure 103: Adding a VLAN to an MST Instance 212